Dell 1135N Service Manual page 98

Message
DHCP problem:
Auto IP Run
Document Jam.
Remove Jam
Door Open.
Close it
Error #02-000~2
Turn off then on
Install Toner
Install it
Memory Full
Remove Job
Network Problem:
IP Conflict
Not Compatible
Toner cartridge
Output bin Full
Remove paper
Service Manual
Alignment and Troubleshooting
Meaning
The IP address assignment is failed.
This happens, when Auto IP for DHCP
is not set in SyncThru Web Service.
The loaded original has jammed in the
ADF.
The front cover is not securely
latched.
A fuser error has occurred.
The toner cartridge is installed
improperly, or not installed.
The memory is full.
The IP address is used elsewhere.
The indicated toner cartridge is not
suitable for your machine.
The output tray is full.
Or the sensor is not facing down.
4-25
Suggested solutions
Change the IP address assignment
method to BOOTP or Static. If you
do not change this option, the DHCP
server continually asks to assign the
IP Address.
Open the ADF cover and clear the jam.
1. Close the cover until it locks into
place.
2. Enter the EDC mode and check the
cover status.
1. Turn the printer off and back on to
continue.
2. Reconnect the cable between the
fuser and SMPS board.
3. Remove the fuser and re-install it.
4. Check the thermostat. If it is
defective, replace it.
5. If error persists, replace the fuser.
6. If error persists, replace the SMPS/
HVPS board.
Reinstall the toner cartridge two or
three times to confirm it is seated
properly. If the problem persists, the
toner cartridge is not being detected.
Press the left/right arrow to highlight
Cancel or Start, then press OK. If you
select Cancel , the machine stops the
fax job. If you select Start, the machine
only sends scanned documents of the
fax job.
Check the IP address or obtain a new
IP address.
Install the corresponding toner
cartridge with a Samsung-genuine
cartridge.
Remove papers from the output tray,
the machine resumes printing. Or
make sure the sensor is facing down.