Troubleshooting and Removal/Replacement Procedures
Removing and Replacing the DDS-2 Drive
To open your system, remove and reinstall the DDS-2 drive, refer to the Owner's Guide
that came with your system. Read "Preparing to Install the DDS-2 Drive" in Chapter 1 of
this guide before beginning an installation.
Adding or Removing the DDS-2 Drive Bezels and Expansion Brackets
Depending on the size of the drive opening in your system, you may need to add or
remove a bezel or expansion brackets to ensure that your DDS-2 drive fits in your
system.
NOTICE:
Before performing any of these changes, make sure there is not a
cassette in the drive.
To add a bezel (it can be a 3.5-in bezel, or a 5.25-in bezel) to your drive, push
onto the drive, making sure the tabs click into place. Refer to Figure 3–1.
To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel
tabs from the sides of the drive. Refer to Figure 3–2.
To add or remove expansion brackets to the drive, use a T10 torx wrench to ei-
ther tighten or remove the four torx screws that hold each expansion bracket to
the drive. Refer to Figure 3–3.
3–10