Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Zanussi ZWG 7120 P
Summary of Contents for Zanussi ZWG 7120 P
- Page 1 User manual Washing Machine ZWG 7120 P ZWG 7140 P...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ 19... - Page 3 is not pressing the electrical supply cable against the • The detergent dispenser drawer is provided with an wall. insert for liquid detergent. Do not use the insert down- wards for gelatinous detergents, with programmes in- • Install the appliance on a flat hard floor. cluding prewash, with the delay start option.
-
Page 4: Frost Precaution
To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise un- groove is horizontal. If til the groove is vertical. necessary use a coin. -
Page 5: Product Description
Ecological hints • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a To save water, energy and to help protect the environment, lower temperature. we recommend that you follow these tips: •... -
Page 6: Installation
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 6 kg Spin Speed Maximum 1200 rpm (ZWG7120P) 1400 rpm (ZWG7140P) Installation Unpacking Warning! • Read carefully the "Safety information" chapter before installing the appliance. • Remove the cardboard top. •... - Page 7 • Remove the power supply cable and the draining and inlet hose from the hose holders ( C ) on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. Positioning and levelling •...
- Page 8 Firstly form a hook in the end of the drain hose using the plastic hose guide supplied with the appliance . The end of the drain hose can be positioned in three ways: • Hooked over the edge of a sink using the plastic hose guide.
- Page 9 The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your Local Centre. Connections overview 115 cm 140 cm Electrical connection • Do not pull the mains cable to disconnect the appli- ance.
-
Page 10: First Use
First use • Ensure that the electrical and water connections machine, to remove any manufacturing residue comply with the installation instructions. from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and • Ensure that the drum is empty. start the machine. - Page 11 not recent since the cellulose structure will already have Close the door gently been damaged and the fabric tends to hole. Mould stains : treat with bleach, rinse well (whites and Warning! Make sure fast coloureds only). that any fabrics were Grass : soap lightly and treat with bleach (whites and fast not trapped when closing coloureds only).
- Page 12 If the water hardness degree is medium or high we suggest • Remove the drawer. Push the drawer edge outwards you to add a water softener following always the manu- where indicated by the arrow (PUSH) to facilitate facturer’s instructions. drawer removal.
- Page 13 Measure out the fabric softener Warning! Do not use the flap in "DOWN" position with: Pour fabric softener or any • Gelatinous detergent or thick detergent. additives into the com- • Powder detergent. partment marked • With programmes with prewash. not exceed the «MAX»...
- Page 14 Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 9 starts flashing: the appliance is now switched on. Programme selector dial If you turn the programme selector dial to another programme when the appliance is working, the red pilot light of the button 9 will flash 3 times and the message Err is displayed to indicate a wrong selection.
- Page 15 Super Quick By pressing this button the corresponding pilot light illuminates. Short cycle for lightly soiled items or for laundry which needs only fresh- ening up. With this option, a reduced load of laundry is recommended: • Cottons 3 Kg •...
- Page 16 The display shows the following information: 7.1 Delay Start icon 7.2 Child safety lock This device permits you to leave the appliance unattended during it's func- tioning. • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ).
- Page 17 The programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Before you start the programme, if you wish to delay the start, press this button to select the desired delay.
- Page 18 Start the programme by pressing the button 9 • To start the selected programme, press the button 9 , the corresponding green pilot light stops flashing. The pilot light 10 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the appliance will begin the countdown.
-
Page 19: Washing Programmes
display go off. The green pilot light of the button 9 flashes Door seal with a low frequency. By pressing any button the appli- ance will come out of the energy saving status. At the end of every cycle, check from the door seal and remove objects that could be trapped in the fold. - Page 20 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry MIXED FABRIC 20° Main wash - Rinses - Maximum spin speed: 900 rpm for SPIN REDUCTION, ZWG7120P - 1200 rpm for ZWG1740P RINSE HOLD,...
-
Page 21: Consumption Values
Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry SPIN Drain and long spin at maximum spin speed: 1200 rpm for ZWG7120P - 1400 rpm for ZWG1740P Max. -
Page 22: Care And Cleaning
Programme Energy consumption Water consumption (litres) Programme duration (KWh) (Hours.Minutes) Cottons 60° 1.30 1.02 Cotton ECO 60° Cottons 40° 0.75 the display on the control panel. Synthetics 40° 0.60 Delicates 40° 0.60 Wool/ Handwash 30° 0.40 1) « Cotton Eco » at 60°C with a load of 6 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. - Page 23 • Use the previous brush to clean the recess, en- suring that upper and lower part of it is well cleaned. After having cleaned the dispenser and the drawer re- • remove the filter and clean it under the tap; cess, replace it.
-
Page 24: What To Do If
Cleaning the water inlet filters • Screw the hose back onto the tap. Make sure the connection is tight. Important! If the appliance doesn't fill, it takes a long time to fill with water, the starting button flashes red or the •... - Page 25 Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emergency drain: •...
- Page 26 Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. •...
- Page 27 Malfunction Possible cause / Solution The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. The appliance vibrates noisi- • Adjust the feet. The laundry is not evenly distributed in the drum. •...
- Page 28 The necessary data for the service centre is on the rating plate. We recommend that you write the data here: Mod..Prod. No..Ser. No..Model description ....... (MOD.) Product number (PNC) ....... Serial number (S.N.) .......
- Page 32 www.zanussi.com/shop...