Camera Selection; Basic Operations Camera Selection - JVC RMP-2580U - Remote Controller For Color Domes Instructions Manual

2. BASIC OPERATIONS

CAMERA SELECTION

Selecting a Desired Camera
CAMERA display POSITION display
REMOTE CONTROL UNIT REMOTE CONTROL UNIT
CAMERA CAMERA POSITION POSITION
PO POWER WER
ALARM ALARM
KEY LOCK KEY LOCK
CAMERA/POSITION CAMERA/POSITION
1 2 3
CAMERA CAMERA POSI- POSI-
TION TION
4 5 6
OPTION OPTION OPTION OPTION
1 2
7 8 9 AUTO AUTO AUTO AUTO
PAN PAN PATROL PATROL
0
CLEAR CLEAR ENTER ENTER
/HOME /HOME
CLEAR button - button
ENTER button
Camera operation details
POSITION
Position display
(Example with the
home position)
POSITION
Fixed camera display
10
RM-P2580 RM-P2580
AUTO AUTO F-1 F-1 F-2 F-2 F-3 F-3
CAMERA
button
PAN/TILT PAN/TILT
Numeric key
buttons
+ button
POSITION
AUTO PATROL
( REF. : Page 15)
POSITION
AUTO PAN
( REF. : Page 14)
1.
Press the CAMERA button so that the indicator lights up.
2.
Input the camera number using the numeric keys (0 to 9).
The input figure is shown in the
CAMERA display together with
a period after it. (Example: When
"8" is input)
To clear the input figure, press
the CLEAR button.
3.
Press the ENTER button to enter the input camera number.
The video of the selected camera will be output from the
MONITOR OUTPUT connectors on the rear panel.
At this time, the period in the CAMERA display disappears
and the POSITION display shows the camera operation
details (position, fixed camera, AUTO PATROL, AUTO
PAN, etc.).
NOTES
"Camera video" is one of the video signals input to
the VIDEO INPUT connector of this unit or to the frame
switcher.
In the case of the B mode in which the output video is
controlled by the frame switcher, in order to allow cam-
era selection from this unit, connect the SERIAL-2
connector on the rear panel of the unit with the RS-
232C connector of the frame switcher. (SW-D7000/
SW-D8000)( REF. : "APPLIED SYSTEM (B MODE)"
on page 22.)
4.
To view the video of the next camera number, press the +
button. To view the video of the previous camera number,
press the – button.
NOTES
When no camera is connected to a camera number,
the camera number is skipped.
Be sure to set each camera ID to the same number
as the corresponding VIDEO INPUT connector. Er-
roneous settings may cause operational difficulties.
CAMERA
Period