Identifying server components Front panel components SL165s G7 Server Front Panel Components Figure 1 Front panel components of the s6500 chassis with 4 SL165s G7 servers Item Description UID LED/Switch Serial port Top: NIC4 Connector Bottom: NIC3 Connector Server 1 Server 2 Server 3 Power LED/Switch...
You need to remove the tray from the chassis before you can remove or installation of options, refer to any installation instructions that replace a tray component. came with the option, as well as the HP ProLiant SL165s G7 Server To remove the tray: Maintenance and Service Guide.
NOTE: For specific supported hard drive configurations and NOTE: cable routing, refer to HP ProLiant SL165s G7 Server SR = Single Rank, DR = Dual Rank, QR = Quad Rank. Maintenance and Service Guide located on the HP website: http://www.hp.com/support/ProLiant_SL165sG7_MSG_en Population rules must be followed for both processors.
Properly align the heat sink mounting pins to the system board Installing the Processor mounting holes. To install the new processor: Tighten the mounting pins clockwise to secure the heat sink connection to the system board. Insert the processor in the tool. CAUTION: To prevent the heat sink from tilting to one side Align the processor installation tool with the socket and install the during installation/removal, turn each screw a couple of turns,...
Figure 12 Installing the DIMM air baffle into the tray Additional Documentation For additional documentation, refer to HP ProLiant SL165s G7 Server Easy Set-up CD. You can also access additional information and documentation from the HP external website, either by connecting directly or through the Easy Set-up CD.