1.
Remove the SBC.
2.
Remove the SCSI adapter board from the SBC.
3.
Inspect and if necessary replace fuse F3 as shown in Figure 3–1. The fuse has
no polarity, so fuse can be oriented in either position in the socket.
4.
Replace the SCSI adapter.
5.
Replace the SBC.
If you verify that you correctly installed and configured your FWD SCSI adapter and you
still have a problem, contact your designated service representative.
Fuse F3
Contact Pins
125 V
2A
LF
Figure 3–1. Replacing Fuse F3
Troubleshooting
Fuse Socket
3–5