Power Sources; Using The Battery; Using The Ac Adaptor - Panasonic AG-HMC80PJ Operating Instructions Manual

Power sources

Using the battery

Installation
Insert the battery until it clicks into place.

Using the AC adaptor

Installation
1
Connect the DC cable to the AC adaptor.
2
Plug the AC power supply cable into the
power outlet.
3
Insert the DC cable's battery connector until
it clicks into place.
6
DC cable's battery
connector
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the battery while pressing the
battery release button.
• The lock can be released and the battery
removed.
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the DC cable's battery connector
while pressing the battery release button.
3
Disconnect the AC power supply cable from
the power outlet.
• Battery cannot be recharged when the DC
cable is connected to the AC adaptor.
• Disconnect the AC power supply cable from the
power outlet when the unit is not going to be used.
CAUTION:
• This apparatus can be operated at a voltage in
the range of 110 – 40 V AC.
Voltages other than 10 V are not intended for
U.S.A. and Canada.
Operation at a voltage other than 10 V AC may
require the use of a different AC plug.
Please contact either a local or foreign
Panasonic authorized service center for
assistance in selecting an alternate AC plug.