Managing Hardware Setup
Figure 6-4
Clamp
32 inches
Positioning the Table and Starting the Calibration Procedure
To correctly position the table and configure the Cisco TelePresence software for use with the CTS 1100
camera, follow these steps:
Step 1
Position the table so that it fulfills the following requirements:
•
•
•
Cisco TelePresence System Release 1.5 Administrator Guide
6-8
Easel and Target After Assembly
The front edge of the table is a minimum of 44 inches (112 cm) away from the display.
The sides of the table are evenly positioned on each side of the CTS 1100.
The rear edge of the table is between eight and 12 feet (244 and 366 cm) away from the display.
32 inches
Chapter 6
Troubleshooting the CTS 1100
OL-13676-04