Cabling - Motorola 9000SM - Canopy 900 MHz Subscriber Module User Manual

CABLING

The following information describes the wiring standards for installing a Canopy system. All
diagrams use the EIA/TIA 568B color standard.
Currently shipping modules auto-sense the Ethernet cable type – either RJ-45 straight-thru cable or
RJ-45 crossover cable can be used to connect a network interface card (NIC), hub, router, or
switch to a module.
Earlier modules did not auto-sense. In cases where older modules are used:
•
When connecting a Canopy device directly to a network interface card (NIC)
use a RJ-45 straight-thru cable.
•
When connecting a Canopy device directly to a hub, switch, or router use a
RJ-45 crossover cable.
When using the Canopy AC wall adapter the +V is +11.5VDC to +30VDC with a nominal value of
+24 VDC, and the maximum Ethernet cable run with the AC wall adapter is 328 feet (100 meters).
RJ-45 Straight-Thru:
pin 1 →
white / orange
pin 2 →
orange
pin 3 →
white / green
pin 4 →
blue
pin 5 →
white / blue
pin 6 →
green
pin 7 →
white / brown
pin 8 →
brown
Pins 4, 5, 7, and 8 are used to carry power to the Canopy modules.
RJ-45 Crossover:
pin 1 →
white / orange
pin 2 →
orange
pin 3 →
white / green
pin 4 →
blue
pin 5 →
white / blue
pin 6 →
green
pin 7 →
white / brown
pin 8 →
brown
Pins 4, 5, 7, and 8 are used to carry power to the Canopy modules.
SM User Manual Issue 2
← pin 1
← pin 2
← pin 3
← pin 4
← pin 5
← pin 6
← pin 7
← pin 8
← pin 3
← pin 6
← pin 1
← pin 4
← pin 5
← pin 2
← pin 7
← pin 8
Page 17 of 34