Disassembly - Pioneer 434CMX - PDP - 43" Plasma Panel Service Manual

5

7.1.8 DISASSEMBLY

1
Rear Case (43M), Front Case 434 (CMX)
1
Remove the grip by removing the four screws.
2
Remove the six screws.
3
Remove the sixteen screws.
Note :
When reattaching the rear case (43M), first attach
the screws for the holes indicated with ∗1 to place
the rear case (43M) in the correct position.
4
Remove the rear case (43M).
Note:
• When reattaching the grip, be sure to securely
tighten the screws.
• An installation direction of the grip of PDP-
434CMX/ PDP-43MXE1 and PDP-43MXE1-S
(43-inch) is different from PDP-504CMX/ PDP-
50MXE1 and PDP-50MXE1-S (50-inch).
(Refer to the right figure.)
5
Remove the three screws.
6
Remove the one rivet.
7
Remove the lead cover (4G).
8
Disconnect the flexible cable.
9
Remove the front case 434 (CMX).
Note:
If only the front case must be removed,
without removing the rear case, perform the steps 5 to 9.
5
6
3
2
3
1
2
Grip
3
1
∗1
3
2
3
3
50-inch 43-inch
Inner Inner
side side
Grip attachment position
Front case 434 (CMX)
6
Rivet
Turn it not to press the rivet.
(Because when the rivet presses, fit in once again.)
PDP-434CMX
6
7
Rear case (43M)
3 3 3
3
3
4
∗1
3
3
3 3
43-inch
Inner
side
Grip attachment position
First pull the lower part of the
front case 434 (CMX) out
toward you then lift the case up.
9
5
×3
KEY CONTROL
Assy
Lead cover (4G)
7
8
A
2
1
2
Grip
1
2
B
3
50-inch
Inner
side
C
D
E
4 8
7
Lead cover (4G)
F
111
8