Carved Fill Properties - Brother Pacesetter BES Lettering Instruction Manual

76 Pacesetter BES Lettering
Instruction Manual
A general rule is to go for full-fabric coverage, but add extra
stabilizer if you want to support a high-density fill on a low-
density fabric.
For larger text objects, particularly when you exceed the maxi-
mum recommended height of a font, you will probably want to
use Fill stitches. Fill stitches are the type you would normally
find filling an area in an embroidery design. With Fill stitches,
each line across is made up of two or more individual stitches.

Carved Fill Properties

In addition to the density and stitch-length settings described
above there are a few extra fill settings that apply only to the
Carved fills. You can adjust these Carved pattern settings in the
Properties box. The settings allow you to change a fill pattern's
characteristics such as the size and angle of the fill pattern.
The following figures show some different effects you can
create using the Carved Fill settings.
Original (scale at 100%)
To change the Emboss Scale of a Carved pattern:
1 Select a Carved fill segment
2 In the Fill area of the Properties Panel, do the following:
Click the Emboss Scale box to select this property.
In the Emboss Scale field, enter a percentage value to
adjust the scaling.
3 Click Apply.
Emboss Scale at 50%