Selecting A Stitch; Saving Stitch Settings; Using The Mirror Image Key - Brother NX-2000 Operation Manual

Selecting a Stitch

a
Turn on the machine, and then lightly press
the display.
→ Depending on the setting, either "Q-01 Piecing
stitch (Middle)", "1-01 Straight stitch (Left)" or "1-03
Straight stitch (Middle)" is automatically selected.
b
Press
of the stitches in the selected category, and
then select a stitch.
→ An image of the selected stitch is displayed below
the symbol of the appropriate presser foot.
Memo
For details on the stitches, refer to "STITCH SETTING
CHART" at the end of this manual.

Using the Mirror Image Key

Press so that it appears as
image of the selected stitch is created.
Note
If appears as
multi-directional sewing patterns, etc.) is selected, a
mirror image of the selected stitch cannot be created.
to display a screen
. A mirror
after a stitch (buttonholes,
SELECTING A UTILITY STITCH

Saving Stitch Settings

This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread tension,
automatic thread cutting, automatic reverse/
reinforcement stitching, etc. However, if you wish to
save specific settings for a stitch so that they can be
used later, press after changing the settings to
save the new settings with the selected stitch.
Example: Using a stitch length of 2.0 mm for the
straight stitch
a
Press , and then select a straight stitch.
Memo
The default stitch length is 2.5 mm.
b
Set the stitch length to 2.0 mm.
c
Press .
* To reset the selected stitch to its default settings,
press , and then press
3
.
51