clear cable modem lock
clear cable modem lock
To reset the lock on one or more CMs, and to reinitialize them, so that they can reregister with a valid
DOCSIS configuration file, use the clear cable modem lock command in privileged EXEC mode.
Syntax Description
mac-addr
ip-addr
cable slot/port
cable slot/subslot/port
all
oui string
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
When you have configured the
"locks" CMs that use a DOCSIS configuration file that fails the CMTS verification check. These CMs
are allowed to come online, but with a restrictive QoS configuration that limits their service flows to
10 kbps.
Locked CMs will not be allowed to reregister with a valid DOCSIS configuration file until they have
been offline, without attempting to reregister, for at least 24 hours. You can manually clear the lock on
a CM by using the clear cable modem lock command in privileged EXEC mode.
Cisco Broadband Cable Command Reference Guide
2-384
clear cable modem {mac-addr | ip-addr | all | oui string} lock
Modification
This command was introduced.
Specifies the 48-bit hardware address (MAC address) of an individual
CM.
Specifies the IP address of an individual CM.
Identifies the a interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
Identifies a cable interface on the Cisco uBR10012 router. The
following are the valid values:
slot = 5 to 8
•
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
Resets the lock for all CMs.
Resets the lock for all CMs from a vendor that matches the specified
Organization Unique Identifier (OUI). The string parameter can be
either the three byte hexadecimal string (such as 00.00.0C) or a vendor
name that has been defined using the cable modem vendor command.
cable dynamic-secret lock
Chapter 2
Cisco CMTS Configuration Commands
command on a cable interface, the CMTS
OL-1581-08