Cis Scanner Area Setting; Eeprom Customizing - Brother FAX255 Service Manual

3.10 CIS Scanner Area Setting

n n
Function
The equipment sets the CIS scanner area and stores it into the EEPROM.
n n
Operating Procedure
(1) In the initial stage of the maintenance mode, set the "adjusting sheet A" on the document
stacker.
(2) Press the 5 key twice.
The "SCANNER AREA SET" will appear on the LCD.
The equipment checks and sets the area to be scanned.
If no error is noted, the equipment returns to the initial stage of the maintenance mode.
If any error is noted, the "SCANNER ERROR" will appear on the LCD.
equipment to the initial stage of the maintenance mode, press the Stop key.

3.11 EEPROM Customizing

n n
Function
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings. The customizing codes list is given in Appendix 1.
NOTE: If you replace the main PCB or CIS, be sure to carry out this procedure.
n n
Operating Procedure
(1) Press the 7 and 4 keys in this order in the initial stage of the maintenance mode.
The current customizing code (e.g., 1101 in the case of FAX275 U.S.A. versions) appears.
(2) Enter the desired customizing code (e.g., 0102 in the case of FAX275 Canadian versions).
The newly entered code appears.
NOTE: If a wrong 4-digit code is entered, the equipment will malfunction.
(3) Press the Start key.
The equipment saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop key or no keys are pressed for one minute in the above procedure, the
equipment stops the procedure and returns to the initial stage of the maintenance mode.
V - 55
To return the