Adjusting The Position Of The Mirror (Optical Path Length Between No. 1 Mirror And No. 2/No. 3 Mirror) - Canon NP6330 Service Manual

2 Adjusting the Position of the Mirror (optical path length between No. 1
mirror and No. 2/No. 3 mirror)
1) Remove the screw used to temporarily fix the No.2 mirror mount in position (both
front, rear).
2) Loosen the four screws on the mirror positioning tool (FY9-3002-000), and extend
the two arms fully; then, tighten the screws (both front and rear).
Reference:
The mirror positioning tool is used in common with other models. Adjust the length
of the arms to suit the copier in advance.
3) Remove the pin from the mirror positioning tool (front and rear).
4) Mount the mirror positioning tool
mount.
COPYRIGHT © 1997 CANON INC.
to the No.1 mirror mount and the No.2 mirror
(front)
Figure 11-215
Figure 11-216
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
(rear)
11-23