Problems With The Load Size Indicator Or Calibrating To Zero - Miele W 2839i WPM Operating Instructions Manual

Problem solving guide

Problems with the load size indicator or calibrating to zero

Problem
The display indicates
<25%
a load of
load size is indicated
when the drum is
full.
The display indicates
25%
a load of ,
75% 100%
or when
the drum is empty
The fault message:
Zero setting
not possible
appears in the
display.
44
Possible cause
There was already
or no laundry in the drum
when the machine
was switched on.
This has decalibrated
the sensor from the
zero setting.
The load size sensor
50%
, has been
decalibrated from the
zero setting.
The drum door is
closed.
Remedy
^ To recalibrate the sensor to the
zero setting:
– Remove the laundry from the
drum.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Press the Cottons programme
button.
– Press and hold the Load/
Detergent button pressed in
until the following message
appears in the display:
Zero setting
OK.
Rotate the drum once. If the
display still indicates a load of
25% 50% 75%
, ,
recalibrate the sensor to zero
again (see above section)
– Open the drum door.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Try and recalibrate to zero
again.
100%
or ,