Epson BrightLink 450Wi Using page 2

2 Remove the channel covers, then attach the channels and connector pieces to your wall using the adhesive
backing. To orient the parts correctly, note the following:
• When connecting two channels together, you need to make sure the tracks inside the channels line up
where the pieces meet. Colors are marked on the ends of the tracks to assist with this. You may have to
rotate a length of channel end-for-end to make the tracks (and colors) line up.
• When using a corner connector, make sure the tracks inside the corner connector and in the two
channels all line up.
3 Use the included drywall screws to secure the channels and connector pieces to the wall. Insert the screws
at the pre-drilled locations.
Note
Depending on your installation, it may not be necessary to insert screws at all the pre-drilled locations (for example,
you may be able to insert a screw in every other hole).
4 Starting from the top, press the cables into their respective tracks in each channel. Use a blunt tool, such as
a screwdriver handle, to press the cables into place. Press the smaller cables in first, and the large cable last.
Note
The individual tracks inside the channel are sized differently. Be sure to place the correct cable in each track. You
may need a second person's help to hold the cables while pressing them in the tracks.
Optional cable for microphone,
audio, etc. (red track)
USB cable (green track)
5 Press the covers in place on each channel and connector piece.
6
Apply a seam cover to disguise the seam where two pieces meet. Remove the adhesive backing from the
seam covers to apply them.
Power cord (black track)
VGA computer cable (blue track)