Wiring Examples; Voltage Input; Bipolar Voltage Input; Current Input - Hitachi L300P Series Instruction Manual

The examples below show how the use of the [AT] input during operation enables/disables the
Trim Frequency Command input [O2]—[L]. The [O2]—[L] input may be used alone, or as an
offset control for the primary analog input.
Example 1: Without reverse
[FW] terminal
[AT] terminal
External frequency
command
0
[O/OI] terminal
Trim frequency
0
command
[O2] terminal
Actual frequency 0
command

Wiring Examples

Using an external potentiometer is a common way to
control the inverter output frequency (and a good way
to learn how to use the analog inputs). The potentiome-
ter uses the built-in 10V reference [H] and the analog
ground [L] for excitation, and the voltage input [O] for
the signal. By default, the [AT] terminal selects the
voltage input when it is OFF. Take care to use the
proper resistance for the potentiometer, which is
1 to 2kΩ, 2 Watts.
Voltage Input – The 0–10V voltage input circuit uses terminals [L] and [O]. Attach the signal
cable's shield wire to terminal [L] on the inverter only. DO NOT ground the shield at its other
end. Maintain the voltage within specifications (do not apply negative voltage). Normally a
full-span input level (10V) will give the maximum motor frequency. You can use parameter
A014 to select a lower voltage for full output frequency (such as using a 5V input signal).
Bipolar Voltage Input – The -10 / 0 / +10V voltage input circuit uses terminals [L] and [O2].
Attach the cable's shield wire to terminal [L] on the inverter only. Maintain the voltage within
specifications. Only apply a negative voltage if this input is configured for bipolar use.
Current Input – The current input circuit uses terminals [OI] and [L]. The current comes from
a sourcing type transmitter; a sinking type will not work! This means the current must flow into
terminal [OI], and terminal [L] is the return back to the transmitter. The input impedance from
[OI] to [L] is 250 Ohms. Attach the cable's shield wire to terminal [L] on the inverter only.
F
OI
F
O
F
O2
F + F F + F
O O2 OI O2
Standard Voltage Input
FM
H O2 AM
AMI
L O OI
– +
0 to 9.6 VDC,
0 to 10V nominal
Example 2: With reverse
[FW] terminal
[AT] terminal
External frequency
command
0
[O/OI] terminal
Trim frequency
0
command
[O2] terminal
Actual frequency 0
command

Bipolar Voltage Input

FM
H O2 AM
AMI
L O OI
– +
-10 to 9.6 VDC,
0 to 10V nominal
See I/O specs on page 4–8.
L300P Inverter
F
OI
F
O
F
O2
forward
reverse
F + F F + F
O O2 OI O2
FM
H O2 AM
AMI
L O OI
1 to 2 kΩ, 2W
L H

Current Input

FM
H O2 AM
AMI
L O OI
4 to 19.6 mA DC,
4 to 20 mA nominal
4–53