Change The Light Bulb; Troubleshooting - Bosch Nexxt Series Operating, Care And Installation Instructions Manual

Change the Light bulb
The dryer light turns on inside the
drum when you open the door,
To change the light bulb:
Set program setector to "Off",
Turn off the circuit breaker,
Putl out power supply plug,
Open the door and locate the
tight bulb on the upper teft side
of the seaI,
Loosen the screw of the cover
and open the cover.
Turn bulb counterclockwise.
Replace the butb with a new
appliance bulb only (obtainable
through parts department).
Replace the cover and secure
with the screw.
Plug in dryer or reconnect
power supply.
Trou
TO AVOID RISK OF
ELECTRICAL SHOCK!
Repairs or replacement of parts
may be carried out by authorized
technicians oniy.
Before calling the customer service,
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
1. Set program selector to "OFF".
2. Turn off the circuit breaker.
3. Putl the main plug out of the
socket.
4. Call customer service
(see page 25).
Problem
Dryerdoesnc/[start.
"Start/Stop"indicatorlight doesnot
illuminate.
Programhasbeen interrupted."Lint
filter" indicatorlight illuminates,
a warningsignalis emittedand the
displayshows"]E:O i ".
Degreeof dryinghasnot beenreached
or the dryingtime istoo long.
Displaymay indicate"E:OS".
Possiblecause
Main plugnot inserted at all or not insertedcorrectly.
A fuse of powersupplyhastripped.
"Start/Stop"buttonnot pressed.
No programselected.
Doornot closed.
Ambienttemperaturebelow41 °F/5 °C.
Lint filter dirty.
Exhaust a ir duct is blockedor too long,
Fault in programsequence or malfunction,
The room/cabinet i s not adequately ventilated.
Moisturesensordirty.
Exhaustair duct is blockedor too long.
Remedialaction
Insertmainplug correctly.
Replace/switch o n fuse.
Press"Start/Stop"button.
Selectprogram.
Closedoor.
Increaseroomtemperature.
Cleanfilter asdescribedon page23.
Switchoff/switchon again.
Cleanexhaustair duct, Reduce exhaustair duct to
maximumlengthas described on page10.
Switchoff/switchon again.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.
Restartprogram.
Providean adequatesupplyof fresh air.
Switchoff/switchon again.
Cleanmoisturesensoras described on page23.
Switchoff/switchon again.
Cleanexhaustair extraction.Reduce exhaustair duct
to maximum lengthas described on page10.
Switchoff/switchon again.
24