SERVICE
AND ADJUSTMENTS
_b
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come
into contact with plug.
J
TILLER
TO ADJUST
HANDLE
HEIGHT
(See Fig. 18)
Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
•
First loosen handle lock lever.
•
Handle can be positionedat differentsettings between
"HIGH" and "LOW" positions.
•
Retighten handle lock lever securely after adjusting.
HANDLE
(HIGH PosmoN)
HANDLE LOCK
LEVER
HANDLE
(LOW POSITION)
FIG. 18
TIRE
CARE
CAUTION:
When mounting tires, un-
less beads are seated, overinflation can
cause an explosion.
CLEVIS
i
HAIRPIN
CLIP
J
OUTER
SIDE
SHIELD
INNER SIDE
SHIELD
FIG. 19
TO REMOVE
BELT GUARD
(See Fig. 20)
NOTE:
For ease of removal, remove hairpin clip and
clevis pin from left wheel. Pull wheel out from tiller about
1 inch.
•
Remove two (2) screws from side of belt guard.
•
Remove hex nut and washer from bottom of belt guard
(located behind wheel).
•
Pull belt guard out and away from unit.
•
Replace belt guard by reversing above procedure.
•
Maintain 20 PSI (1.4 kg/cm 2) of tire pressure.
If tire
pressures are not equal, tiller will pull to one side.
•
Keep tires free of gasoline or oil which can damage
rubber.
TO REMOVE WHEEL (See Fig. 19)
•
Place blocks under transmission to keep tiller from
tipping.
•
Remove outer side shield by removing nuts "A" and
•
Remove inner side shield by removing nuts "C" and
•
Remove hairpin clip and clevis pin from wheel.
•
Remove wheel and tire.
•
Repair tire and reassemble.
BEN GUARD
AND
WASHER
SCREW
CLEVIS PIN
FIG. 20
13