Brother BES Monogramming Suite Instruction Manual page 38

36 Pacesetter BES Monogramming Suite
Instruction Manual
4 If desired, change the height of the font by typing a new
value into the Font Height field of the dialog.
For "Name Template" monogram styles, there will be two
Height fields - 'Font 1 Height' to change the height of the
monogram lettering, and 'Font 2 Height' to change the height of
the name.
Again, there is an exception for the "Name only" style - in this
case the height of the name will be controlled by the 'Font 2
Height' field.
Each font has maximum and minimum recommended heights;
for best quality on sew-out, you should stay within these limits.
If you enter a font height that is outside of the recommended
range, a warning dialog will appear when you click the Apply
button. This dialog will advise you to change (increase or
decrease, depending on weather you are below the minimum
or above the maximum) the font height until it is within the
recommended range for that font.
5 By default, the monogram lettering will be generated with a
satin fill; however, you can change to a pattern fill by
checking the Pattern Fill box in the dialog.
For "Name Template" monogram styles, there will be two
Pattern fill checkboxes active in the dialog; check Font 1 Pattern
Fill to change the monogram lettering to a pattern fill, and Font 2
Pattern Fill to change the "name" portion to a pattern fill.
If the "Name only" template type is being applied, the Font 1
Pattern Fill box will apply to the "name" text.
6 Add Decors and/or a Frame, if desired.
For more details on adding Decors and Frames, see the
corresponding sections, below.
7 Click Apply to see your changes in the preview panel.
8 When all your changes have been made, click OK.
The design appears in the workspace.