Page 1
OWNER'S MANUAL CRRFTSMIIN Horsepower 1800 2.0 GPM High Pressure Washer Model No: 919.679180 • Safety • Assembly WARNING: Before using this • Operation product, read this manual • Maintenance and follow all Safety Rules and Operating Instructions. • Parts List •...
FULL TWO YEAR WARRANTY ON CRAFTSMAN ENGINE For two years from the date of purchase, when this Craftsman engine is maintained and operated according to the instructions in the owner's manual, Sears will repair, free of charge, any defect in material and workmanship.
SAFETY GUIDELINES - DEFINITIONS This manualcontainsinformation that is important f or you to know and understand. This information relates to protecting YOUR SAFETYand PREVENTINGEQUIPMENTPROBLEMS.Tohelp you recognizethis information,we usethe symbols below. Pleaseread the manualand pay attention to these sections.SAVETHESE DEFINrrloNS/INSTRUCTIONS. A WARNING indicates a potentially hazardous situation which, if not avoided, _...
IMPORTANT SAFETY INSTRUCTIONS (cont'd) WHAT CAN HAPPEN HOW TO PREVENT IT HAZARD Unsafe operationof your pressure • Become familiar with the operation washer could lead to serious injury and controlsof the pressurewasher. RISKOF UNSAFE or death to you or others. •...
Page 5
IMPORTANT SAFETY INSTRUCTIONS (cant'd) WHAT CAN HAPPEN HOW TO PREVENT IT HAZARD • Contact with hot surfaces,such as • Duringoperation,touch onlythe control engines exhaust components, could surfaces of the pressure washer. Keep RISK OF HOT SURFACES result in sedous bum. children away from the pressurewasher at all times.
Page 6
Mount the rubber isolator to the frame. To mount isolatorplace threaded end of bolt Tools Required for Assembly throughthe washer. Adjustable wrench • Next with washer on bolt place threaded end of Allen wrench bolt throughthe largerhole in bottom of the rubberisolator.
Page 7
Pull the cord under the wire bracket to the 7. Place assembled gun and wand on pressure right of the wire loop. washer holder. Lift the pull cord handle up and slide the cord to the left sliding the cord into the wire loop. Next slide handle behind the wire bracket to the left of the wire loop.
Page 8
Before Starting The Engine to operate equipment until you have read Owners To operate the engine you will need to do the following. Manual for Safety, Operation, and Maintenance ARNING: Read Owner's Manual. Do not attempt I Instructions. Note: Yourpressure washer pump is a sealed pump, you should never have to add or change the oil.
Page 9
• Squeeze trigger on pressure washer wand to relieve Use clean, fresh, regular unleaded gasoline with a air pressure caused by turning on the water. Water minimum of 85 octane. Do not mix oil with gasoline. If will spew out of the gun in a thin stream. This will unleaded fuel is unavailable leaded fuel may be used.
Page 10
How To Use Your Pressure Washer Using Soaps/Chemicals On the end of your spray gun is a nozzle that you can IMPORTANT: Use soaps and chemicals that are slide forward and backward and that you can also designed specifically for use with pressure washers, To twist from side to side.
CUSTOMER RESPONSIBILITIES TABLE Every 25 Every50 Every100 MAINTENANCE TASK Beforeeach use hoursor veadv houmorveadv hoursor veadv PRESSURE WASHER Check/clean inletscreen, Check hiah pressurehose. Check soao and chemicalhose and filter Check gun and wand for le_ks, Purge oumoof air and contaminants ENGINE Gheck0il level Char_aeengine oil...
Page 12
Pressure Washer Maintenance Changing Engine Oil Check and Clean Inlet Screen: Examine inletscreen • Change oil while engine is stillwarm. Preferably on pump inlet fitting. Clean if clogged; replace if tom. drain oil from top of engine as illustrated below. Drain oilwith air cleaner side up, Oil can be drained Check High Pressure Hose: High pressure hose can from engine bottom if necessary.
Page 13
Clean Pre-Cleaner and Air Cleaner Cartridge NOTE: Do not use petroleum solvents,e.g., kerosene, which willcause the cartridge to detedorete. Do not use Your engine is equipped with an oval dual element pressurizedair to clean cartridge. Pressurized air can damage the cartridge. air cleaner: the two elements include a foam pre-cleaner and an air cleaner cartridge.
Page 14
3. Pull tdgger on gun handle to relieve any water 7. Direct water supply into nozzleend to backflush pressure. loosened particles for 30 seconds. 4. Disconnect the wand from the gun. 5. Remove nozzle from the the end of the wand with the 2ram allen wrench provided.
Page 15
SYMPTOM CAUSE SOLUTION Engine won't 1. Engine throttle i s in "OFF" Position. 1. Slide throttle to "Run" position. start 2. Choke lever has not bean placed to 2. Slide choke lever to choke position. choke, 3. Pressure buildup after initial use. 3.
Page 16
Hose, Chemical Washer Flat-Engine to Pump 16505 Thermal Relief Valve N130 Lance, Multi-Reg H040 Hose 17569 Decal Craftsman F064 Screw - Hex 5/16" - 18 x 1LG F469 Lock Nut 5/16" ACCESSORIES 17712 Screw HHC, 5/16" (Not Included with Pressure Washer)
Page 17
CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 PUMP BREAKDOWN MODEL PK-17908 s-_O 47 48...
Page 18
CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 PUMP BREAKDOWN MODEL PK-17908 Ref. Part Ref. Part FA-15203000 Oil Seal FA--52234500 By-pass pin FA-13301000 Elastic Ring FA-52068000 Valve seat plate FA-57015402 Oil vented valve assembly FA-52052302 Valve seat FA-52045401 Oil vented valve assembly...
Page 19
CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 BRIGGS ENGINE MODEL #12F802-2017 684t 615e 404_ 10810 307 8 306 11019 L ABELKWl 6356 REQUIRES SPECIAL TOOLS TO INSTALL SEE REPAIR I10ssOWNER'S M ANUAL INSTRUCTION MANUAL REF. PART REF. PART REF. PART...
Page 20
CRAFTSMAN 2400 pSI HIGH pRESSURE WASHER 919.679t80 BRIGGS ENGINE MODEL 912F802-2017 27 O REF. PART REF. PARt" REF. pART DESCRIPTION DESCRIPTION DESCRIPTION 499423 Piston Pin 499429 Piston Assembly 499425 Ring Set (Standard} (Standard) 499424 Connecting Rod (Standard) 94699 Screw (Connecting Rod)
Page 21
CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 BRIGGS ENGINE MODEL # 12F802-2017 tiFF PAnT RF.F. PART ;-II I I'AIII D L::$,r.:m.-"i 'O "-- I'_€,) I]' _;4:1111' II[)N I_ ._;( ; I III'LII)N 691461 Cmnle;h_.ft 222Q91) I Iy_tlOOl K_ 1411 _4.'111 Ilrl_JOKM _, 3_;7A...
Page 23
CRAFTSMAN 2400 PSi HIGH PRESSURE WASHER 919.679180 BRIGGS ENGINE MODEL 1112F802-2017 1=51 PRIMER SYSTEM I e7, 1137< 1_--_'_- 130 95 1100 REF. PART REF, PART REF. PART DESCRIPTION DESCRIPTION DESCRIPTION 94098 Screw ..Note ..498254 Carburetor 497315 Main Jet...
Page 24
BRIGGS ENGINE MODEL # 12F802-2017 CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 365% 708A F_-'] Ic. s,s+ °'+ REF. PART REF. PART FIEF. PART DESCRIPTION DESCRIPTION DESCRIPTION 125A 498965 Carburetor e493765 Idle Mixture Kit 262749 Choke Return Spring Note 94096 Screw...
Page 25
BRIGGS ENGINE MODEL #12F802-2017 CRAFTSMAN 2400 PSi H IGH PRESSURE WASHER 919,679180 Rcr. PP_T ' ;AH Rcr. PA_T "J(1. N¢). r)l-_C:.:-ll P I I,;)N I_F.-_r_,T, ON or.£.cNlr 0_3'i 2 eJ2 _ _tirG:i- Governt:r 2531:144 _prm;_ [_av. Irluludad iraC.,_P_L Sel-_e n_r, i_,>,_.
Page 26
CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 BRIGGS ENGINE MODEL #12F802-2017 L, , .._':) t!,,+! ' tl 940 _,,_" 091_9_0 _ `'" ":_'_]* .." 621 +_ Use With Choke Type, Cm'bulBto¢ "r"11%%11% r... '°:' ,0,<f:/ FART PAH I HH-. HI-F.
Page 27
BRIGGS ENGINE MODEL 112F802-2017 CRAFTSMAN 2400 PSI HIGH PRESSURE WASHER 919.679180 tY I 265 '_ " 265A {_' 334 _' .., ,.. ,_..., ,_-'-,:,..S" ""..:'_ R[F, PA_T RF.F PART PART DESCRIPTION i'qO. NC.. DESGrt.IPTION 61425 396047 .'3 w;_.lp-_IuF_ _'_# _4512 _;ruw...
Bdggs & Stratton Corporation (B&S), the California AirResources Board ( CARB) and theUnited S tates Environmental Protection Agency (U.S. EPA) Emission Control System W arranty Statement (Owner's Defect Warranty Rights a nd Obligations) Inthe intarast of theenvironment, B &Seegines thatmeet stricternis- TO CERTIFIED ENGINES PURCHASED IN CALIFORNIAIN 1995 sionrequirernentsarelabeled,"Thlaenginasontormeto 1995-1998 AND THEREAFTER, WHICH ARE USED IN CALIFORNIA, AND...
Page 35
Bdggs & Stratton welcomes warranty repair and apologizes 4. Pads which are scored or broken because an engine was to you for being inconvenienced. Any Authorized Service operated with insufficient or contaminated lubricating oil, Dealer may perform warranty repairs. Most warranty repairs or an incorrect grade of lebdceting oil (check oil level daily are handled routinely, but sometimes requests for warranty or after every 8 hours of operation.
_ARS OWNER'S MANUAL CRAFTSMAN The model number of your Sears Air Compressor can be found on the maintenance label on the top of the shroud or on the bar code label on the rear of the air tank. MODEL NO.