Epson Stylus CX9475Fax Start Here Manual page 15

Configuring the Print Server and
Installing Software for Ad Hoc Mode
Follow the instructions in this section to set up the CX9475Fax for Ad Hoc mode.
1. Plug the included USB cable into the print server and your all-in-one.
2. Plug one end of the included Ethernet cable into your computer. Then plug
the other end into the Ethernet port on the print server.
3. Plug the print server power adapter into the print server and an electrical
outlet.
4. Make sure your all-in-one is plugged in and turned on.
5. Configure your computer with a static IP address of 192.168.2.xxx (where xxx
is any number between 3 and 254).
6. Open a web browser and type
7. Log into the print server using
Password.
You see a screen like this one:
8. Select
Setup Wizard
Configuring the Print Server and Installing Software for Ad Hoc Mode
192.168.2.2
as the User name and
admin
from the navigation bar at the top.
into the address bar.
1234
as the
15