Download Print this page

Craftsman 152.211620 Owner's Manual page 4

8-in wheel variable speed 1/2 horsepower, 1 horsepower (maximum developed) 1725 r.p.m. to 3450 r.p.m. (no load speed)

Advertisement

Available languages

Available languages

22, CHILDPROOF
THE WORKSHOP
AREA by remov-
ing switch keys, unpUugging tooUs from the eUectricaU
receptacles, and using padUocks,
23, DO NOT OPERATE TOOL IF UNDER THE INFLU-
ENCE OF DRUGS OR ALCOHOL,
24, SECURE ALL WORK, When it is possiMe, use
damps or jigs to secure the workpiece, This is
safer than attempting to hoUdthe workpiece with
your hands,
25, STAY ALERT, WATCH WHAT YOU ARE DOING,
AND USE COMMON SENSE WHEN OPERATING
A POWER TOOL. DO NOT USE A TOOL WHILE
TIRED OR UNDER THE INFLUENCE OF DRUGS,
ALCOHOL,
OR MEDmCATmON,A moment of in-
attention while operating power tooUs may resuUtin
serious personaU injury,
26, ALWAYS WEAR A DUST MASK TO PREVENT
INHALING DANGEROUS
DUST OR AIRBORNE
PARTICLES,
incUuding wood dust, crystalline silica
dust and asbestos dust, Direct particles away from
face and body, AUways operate tooUin well venth
Uated area and provide for proper dust removal
Use
dust collection system wherever possible, Exposure
to the dust may cause serious and permanent res-
piratory or other injury, including silicosis (a serious
lung disease), cancer, and death, Avoid breathing
the dust, and avoid prolonged contact with dust,
Allowing dust to get into your mouth or eyes, or lay
on your skin may promote absorption of harmful
material, Always use properly fitting NIOSH/OSHA
approved respiratory protection appropriate for the
dust exposure, and wash exposed areas with soap
and water,
27, USE A PROPER EXTENSION CORD IN GOOD
CONDITION, When using an extension cord, be
sure to use one heavy enough to carry the current
your product will draw, The table at right shows the
correct size to use depending on cord length and
nameplate amperage rating, If in doubt, use the
next heavier gauge, The smaller the gauge number,
the larger diameter of the extension cord, If in doubt
of the proper size of an extension cord, use a short-
er and thicker cord, An undersized cord will cause a
drop in line voltage resulting in a loss of power and
overheating, USE ONLY A 3-WIRE EXTENSION
CORD THAT HAS A 3-PRONG GROUNDING
PLUG AND A 3-POLE RECEPTACLE THAT
ACCEPTS THE TOOL'S PLUG,
GUJDEUNES
FOR
EXTENSION
CORDS
If you are using an extension
cord outdoors,
be sure
it is marked with the suffix "W-A" CW" in Canada) to
indicate that it is acceptable for outdoor use,
Be sure your extension
cord is properly
sized, and
in good electrical condition, Always replace a damaged
extension cord or have it repaired by a qualified person
before using it,
Protect your extension
cords from sharp objects,
excessive heat, and damp or wet areas,
120 VOLT OPERATION ONLY
25' LONG
50' LONG
100' LONG 150' LONG
0to
6Amps
18AWG
16AWG
16AWG
14AWG
6 to 10 Amps
18 AWG
16 AWG
14 AWG
12 AWG
10to 12Amps
16AWG
16AWG
14AWG
12AWG
SAVE THESE INSTRUCTIONS.

Advertisement

loading