Installing And Removing Drives - Epson ActionTower 3000 Computer User Manual

Chapter 4

Installing and Removing Drives

This chapter describes how to install and remove optional
drives in your computer. You can use these instructions to
install a variety of devices, including hard disk, diskette, tape,
CD-ROM, and optical drives. Although your drive may look
different from the ones illustrated here, you should be able to
install it the same way.
Your computer can hold up to seven mass storage devices, as
described in the table below.
Drive bay
Four externally accessible
bays
One front internal bay
Two rear internal bays
Note
The main system board in your computer supports up to
two diskette drives (or one diskette drive and one tape
drive) and up to two IDE hard disk drives. If you install
more than four drives, you must install a drive controller on
an option card, such as a SCSI controller card, for the
additional drive(s).
Drive type and size
Two 5,25-inch, half-height drives or
one 525-inch. full-height drive
and two 3 S-inch, half-height drives
One 3,5-inch. half-height or third-height
drive
Two 3.5-inch, half-height or third-height, or
one 3.5-inch, full-height drive
Installing and Removing Drives 4-1