Saving Your Settings And Exiting Setup - Epson ActionNote User Manual

Saving Your Settings and Exiting SETUP

When you leave the SETUP program, you can choose to either
save the settings you have changed or exit the program without
saving any changes.
Follow these steps:
1. Press
PRESS F5 TO
PRESS F1 TO EXIT
2. If you want to save your changes, press
want to save your changes, press
system reboots.
3. If you have just run SETUP for the first time, see "Post-SETUP
Procedures," below.
Note
You may see an error message and a prompt to run SETUP
when your computer is rebooting if it detects a problem in
your SETUP configuration. If so, follow the instructions on
the screen to run SETUP and correct the problem.
You may also see an error message if you have not installed
your operating system on the hard disk and you have not
inserted a system diskette in drive A. If you receive this error
message, follow the instructions in your operating system
manual to install the software.
You see the following prompt:
AND EXIT
SAVE
W/O SAVE
Either way, the
Running SETUP 2-15
I f you don't