Ctl Head Position Adjustment - Sony Digital Betacam DVW-707 Maintenance Manual

5-4. CTL Head Position Adjustment

5-4. CTL Head Position Adjustment
Notes
. The CTL head position adjustment is closely related to the CUE/TC head position adjustment.
. After carrying out the CTL head position adjustment, be sure to carry out the CUE/TC head position
check.
Tools
. TP tool
. Alignment tape, ZR2-1 (NTSC)
. Alignment tape, ZR2-1P (PAL)
. Torque screwdriver bit (for M2)
. Torque screwdriver (for 3 kg)
. Oscilloscope
Setting
1. Turn the power off.
2. Connect the 8-pin connector of the TP tool to the connector CN7 on the HN-260 board.
3. Connect the 5-pin connector of the TP tool to the connector CN3 on the CTL-10 board.
4. Set the switches S1-1 and S1-2 on the HN-260 board to OFF.
5. Connect an oscilloscope.
CH-1 : REC RF A/TP tool
CH-2 : PB CTL/TP tool
TRG : SV REF CF/TP tool
6. Turn the power on.
7. Insert the alignment tape ZR2-1/P.
5-18
: J-6420-910-A
: 8-960-073-11
: 8-960-073-61
: J-6325-380-A
: J-6325-400-A
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1