System Requirements To use your printer through the printer’s built-in USB port, you need the following; ® Microsoft Windows 98 USB port USB Interface Cable (shielded) C83623 from Series A 4-pin (computer) to Series B 4-pin (printer) Caution: Using other cables not covered by EPSON warranties (especially cables more than 1.8 meter’s long) may cause the...
Manager of Windows 98. For details, see your computer manual. 1. Turn off your printer, if necessary. 2. Plug one end of a shielded USB cable to the USB connector on the back of the printer. 3. Plug the other end into the computer’s USB connector.
Page 4
Installing the USB Printer Device Driver and Printer Software The USB Printer Device Driver is included in the Printer Software CD-ROM shipped with your printer. If you install the USB Printer Device Driver, the installation program automatically continue to let you install the printer software necessary for using your printer.
Page 5
D:\ win98 (if the CD-ROM drive has a drive letter other than “D”, substitute the appropriate letter). Then click Next. 5. After finishing the USB printer device driver installation, the printer software installation automatically starts and the following dialog boxes appear. Click Finish, then click Next.
Page 6
7. To confirm that installation was successful, check to see if "EPSON USB Printer Devices" appears in the Device Manager. Click Start, point to Settings, and click Control Panel. Then double-click System and click the Device Manager tab.
Try one or more of these solutions: Use the recommended USB cable as described in ”System Requirements” on page 2. If you use a USB hub, connect the printer to the first tier of the hub, or connect the printer to the computer’s USB port directly.