Configuring The Print Server - Epson EpsonNet 802.11b User Manual

Configuring the Print Server

After the software is installed, you're ready to establish a connection to the
print server and configure it for your wireless network.
1. When you see the Wireless Server Search window, click
WP-Admin picks up the signal from the print server and displays server
information like the following:
This information
appears when the
server is found
2. If WP-Admin picks up a signal from more than one server, select the
connection that matches the MAC address on the back of your print
server.
3. Check the signal strength to make sure you have a good link to the print
server. If you have a link, click
If WP-Admin fails to pick up a signal from the print server, try
holding down the print server's test button for at least five
seconds to reset it. The lights go out, then both the green and
yellow lights come on briefly. The yellow light remains on
when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning
on page 40.
Click START
. Then click
STOP
16
START.
This number
indicates the
signal strength
.
CONFIGURE