NEC NP-UM330W Installation And Adjustment Manual page 14

7. Cabling
The power cord and signal cable(s) can be passed through the slide arm and wall adapter.
There is one cable hole in the slide arm and three cable holes in the wall adapter (upward, through-
to-wall and downward).
Select the cable holes to be used according to the cabling conditions.
(1) Pass the cables through the cable hole in the slide arm then to the tip of the arm unit.
(2) Pass the cables through the upper, lower or middle cable hole in the wall adapter.
CAUTION
- Provide enough cable length to allow for adjustment of the slide arm.
- When there are multiple signal cables, bundle them together. Do not bundle them with the
power cord, however. Doing so may cause power-supply noise interference.
Wall adapter
(2) Upward cable hole
Arm unit
Through-to-wall cable hole
(1) Slide arm
Downward cable hole
This completes installation of the projector.
Mount the projector's cable cover and the wall adapter's covers after adjusting the projected im-
age.
ENG-13