Checking The Printer - Epson 7500 User Manual

Installing EPSON Stylus RIP for Macintosh

Checking the Printer

Before you install the EPSON Stylus RIP software, follow the
instructions in your printer's documentation to prepare your
printer for use. Make sure you perform the following steps:
If you'll be using the printer in a "typical" network
configuration (described in the following section), install an
optional network interface card in the printer. See your
printer's documentation for instructions. (Not every
printer has a network interface card option.)
Load paper, install ink cartridges, and allow your printer to
complete its entire ink charging cycle.
Run a printer self test to make sure it operates properly.
Connect the printer directly to your Macintosh or to the
network.
Install the standard non-PostScript EPSON driver and
utilities that came with your printer.
Send a sample print job with the standard printer driver to
make sure the interface connection and cable are secure and
the software is installed correctly.
Once the printer is set up and tested fully, you're ready to
install the EPSON Stylus RIP software on your system.
1-2