Epson Stylus Color 900N User Manual page 49

7. Click
OK
"Configuration is successfully done" appears. (After you click
minutes before turning off the printer, so the settings have time to reach the card.)
Before you can print using TCP/IP, you still need to do the following on each
computer that will use the printer:
Install the printer driver (see page 49)
Add a printer port (see page 51)
See page 46 if you need to enable NetBEUI on the Ethernet card.
Using the arp Command
Make sure the Ethernet card and printer are on the same segment of the network as
the computer you are using to configure the card. Also, you need to know the IP
address for the computer and the IP address you will assign to the printer's Ethernet
card.
Follow these steps to assign the IP address:
1. Click
Start
icon.
2. In Windows 98 or Windows 95, highlight
the
Gateway
In Windows NT, click the
Properties
3. Type
11.22.33.44
Windows 98 or Windows 95, click
4. Click
OK
settings dialog box and save your settings. Click
5. Find the MAC address for the Ethernet card on the status sheet (see page 17).
6. Click
Start
DOS window.
42
to save the new settings. The update is complete when the message
, point to
Settings
tab.
Protocols
. Click the
IP Address
in the Gateway box to set up a default gateway. In
to close the TCP/IP dialog box and then click
, point to
Programs
, click
Control Panel
TCP/IP
tab. Highlight
tab.
.
Add
Yes
, then click the
MS-DOS Prompt
, wait a few
OK
and double-click the
and click
Properties
TCP/IP Protocol
to close the network
OK
to restart your computer.
icon to open a
Network
, then click
and click