Brother Laura Ashley Innov-ís NX2000 Instruction Manual page 11

j
Pulling the upper thread gently, turn the
handwheel toward you so the mark on the
handwheel aligns with the line on the
machine.
→ A loop of the bobbin thread comes out through the
hole in the fabric.
k
Raise the presser foot lever, and then use
tweezers to pull up the bobbin thread and
bring the end of the thread to the top of the
fabric.
Note
• Pull the thread while holding down the fabric so it
does not move out of place.
l
Align the upper thread and bobbin thread,
and then pass them under the presser foot
toward the rear of the machine.
m
While gently holding threads at the rear of the
machine, turn the handwheel to feed the
needle into the punched hole again, and then
lower the presser foot lever.
n
Press or
screen.
→ All keys and operation buttons are unloked, and the
previous screen is displayed.
o
Select a low speed , gently hold the threads
behind the presser foot and start sewing.
Note
• Before sewing, check that there is enough thread in
the bobbin.
p
When you have reached the end of the
stitching area, stop the machine.
Note
• Do not sew reinforcement/reverse stitches at the
end of the stitching, otherwise the threads may
become tangled or the needle may break. In
addition, it may be difficult to pull the bobbin thread
up to the wrong side of the fabric.
q
Raise the needle and presser foot.
r
Leaving about 10 cm (approx. 4 inches) of
thread at the ends, use scissors to cut the
threads.
a
10 cm (approx. 4 inches)
Note
• Do not press the "Thread Cutter" button to cut the
in the
threads, otherwise the machine may be damaged.
9