When Tension Is Applied To The Bobbin Thread; When Tension Is Not Applied To The Bobbin Thread - Brother Laura Ashley Innov-ís NX2000 Instruction Manual

j
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
used.
■ When tension is applied to the bobbin
thread
Insert bobbin into bobbin case so the thread unwinds
from the left side.
Then correctly pass the thread through the tension
spring as shown below.
a
Tension spring
• When winding the bobbin, make sure the thread is
not frayed. Sewing with frayed thread may result in
the thread catching on the tension spring of the
bobbin case, the thread becoming tangled or
damage to the machine.
• Do not guide the bobbin thread through the groove
in the needle plate cover, otherwise the lower
threading will not be done correctly.
6
CAUTION
■ When tension is not applied to the bobbin
thread
If the bobbin thread in the trial stitching is too tight and
adjusting the bobbin case tension does not help, do not
pass the thread through the tension spring.
Hold the bobbin with your left hand so the thread
unwinds from the right side and hold the end of the
thread with your right hand.
k
Pull out about 8 cm (approx. 3 inches) of
bobbin thread.
l
Turn on the sewing machine, and then press
.
→ The screen changes, and all keys and operation
buttons are locked.
Note
• If "OPENING DISPLAY" in the Settings Screen is
turned "ON" press anywhere on the LCD screen
before pressing the icon.