Table of Contents
Advertisement
Optional
components
There
is no sound.
• Refer to General
item "There
is no sound."
(page 18) and check the condition
of the system.
• Connect
the component
properly
(page 17) while
checking:
- if the cords ate connected
properly.
- if the cord plugs are firmly inserted
all the way.
•
TUlll
on
the
connected
component.
• Refer to the operating
in_ructions
supplied
with
the connected
component
and start playing.
• Press MD (page 17).
The sound
is distorted.
• Set the volume of the connected
component
lower.
If the
system
still
does
not
operate
properly
after
performing
the
above
measures,
reset
the
system
as follows:
1
Turn offthe system.
2 While pressing and holding II, turn on the
system.
The system is reset 1o the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
One of the following
messages
may appear or
flash in the display during oper3fion.
CD
NO DISC
There is no disc in tile player.
PGM FULL
You tried to program
31 tracks or more.
PROTECT
Consult
your nearest Sony dealer.
On
operating
voltage
Before operating
tile system,
check that tile operaling
voltage of your system
is identical
with the voltage
of
your local power supply.
On
safety
• The unit is not disconnected
from the AC power
source
(mains)
as long as it is connected
to the wall
ourleL even if the unit itself has been turned
off2
• Unplug
the system from the wall outlet (mains)
if it
is not to be used for an extended
period of time. To
disconnect
the power cord (mains lead), pull it out by
the plug. Never pull the cord itsel£
• Should any solid object or liquid Pall into the system,
unplug
the system
and have it checked
by qualified
personnel
be|bre
operating
it any further.
• AC power cord must be changed only al the qualified
service
shop.
On
placement
• Do not place the system in an inclined
position.
• Do not place the system in locations
where it is;
Extremely
hot or cold
Dusty or dirty
Very humid
Subject m vibrations
Subject to direct sunlight.
• Use caution
when placing
01e unit or speakers
on
surl_aces thai have been specially
treated
(wi¢h wax,
oil, polish, etc.) as staining
or discolorarion
of the
surl_ace may result.
On
heat
buildup
• Although
tile system heats up during operalion,
this
is not a mal|_nction.
• Place the system in a location
with adequate
ventilation
to prevent heal build-up
in the system.
• If you continuously
use this system
at a high volume,
the cannel
temperature
of the top, side and bottom
rises considerably.
To avoid burning
yourself,
do not
touch the cabinet.
• To prevent
a mal|hncfion,
do not cover the
ventilation
hole.
20
Advertisement
Table of Contents
