Setting Up The Remote Control - Sony DSS SAT-A1 Operating Instructions Manual

Setting Up the Remote Control
Selecting IRIRFTransmission
The Set Up Remote screens let you set up the DSS receiver to accept IR
(infrared) or RF (radio frequency) signals from the DSS remote control
and to change the RF security code for the DSS receiver.
in addition to having IR remote control capability, your DSS system
includes an RF feature, which enables the remote control to operate the
DSS receiver even if the receiver is located in another room. In other
words, with the RF feature, the remote control does not require a direct
line-of-sight to the front panel of the DSS receiver.
Note
You must set up the RF antenna to take advantage of the RF feature. See
"Setting Up the RF Antenna" on page 22for details.
The DSS receiver is shipped with IR reception enabled and RF
reception disabled. To use the RF feature, you must change the
factory setting (IR ONLY) to the RF setting (RF ONLY).
To select IR or RF transmission:
1
Select SET UP REMOTE from the Installation Menu.
2 Select REMOTE SIGNAL.
SETUP REMOTE
IRONLY
-
RFSECURIH CODE
000
I he D55 recea_c_ is shit:tJcdwilh only
IR enabled.
3
Select a transmission type (IR or RF) and then select OK to return to
the Setup Remote screen.
SET REMOTE SIGNAL
IRONLY i/ RF ONLY
[,_
4 Select OK from the Setup Remote screen to save your selections
and return to the Installation Menu.
Chapter 6: Using the Installation Menu
69