The ribbon has too much
slack, the ribbon has come
loose, or the ribbon
cartridge is not installed
properly.
The printout is faint.
Cause
The paper-thickness lever is
set incorrectly for your
paper.
The ribbon is worn out.
Part of the printout is missing, or dots are missing in random
positions.
Cause
The ribbon has too much
slack, the ribbon has come
loose, or the ribbon
cartridge is not installed
properly.
The ribbon is worn out.
4-10
Troubleshooting
Remove any slack in the ribbon by
turning the ribbon-tightening knob,
or reinstall the ribbon cartridge as
described on page 1-3.
What to do
Move the paper-thickness lever to a
lower setting. See "Adjusting the
Paper-Thickness Setting" on page 2-2
for instructions.
Replace the ribbon cartridge as
described on page 1-3.
What to do
Remove any slack in the ribbon by
turning the ribbon-tightening knob,
or reinstall the ribbon cartridge as
described on page 1-3.
Replace the ribbon cartridge as
described on page 1-3.