Installing Sliding Guard; Parts Needed - Craftsman 113.206933 Owner's Manual

assembly ,
. 5/Push V_Belt through belt guard just enough to loop
. belt aro'uhd motor pulley_ Place bett: around m0t()r
pu ey but don0t push guard onto guard support at
: thistime. " - - -
6: Position other end of V-Belt onto cutter head pulley.
/ , i
7. Visually line up both pulleys and V-Belt until they are
perpendicular to the floor by sliding motor sideways
as needed,
8. Pressdown hard on motor to put tension on the V-Belt
and tighten the motor mounting bolts at this time.
9. Checkguard support before tightening guard support
screws to be sure it is centered around motor shaft and
will not rub against shaft when motor msrunning.
Tighten screws,
10. Push motor pulley belt guard into position onto guard
support.
tl. Plug motor cord into outlet on switch box installed
earlier through hole provided in stand.
12. Fasten cord along front side stiffener using the two
cord clips.
i i i
INSTALLING SLIDING GUARD
OPEN END
i i
PARTS NEEDED
1 Sliding Guard
1 Sliding Guard Knob
I Sliding Guard Rod
2 Sliding Guard Washers (one side of washer is concave)
2 Hex Hd. Screws 1/4-20x 1/2"
PULLEYS AND V-B ELT
j_MUST BE STRAIGHT IN-LINE
_AT 90° WITH RELATIONSHIP
C_____ TO THE FLOOR
!
t ,----V-BELT
GUARDS REMOVED
..... ! FOR PICTURE CLARITY
i, t STRAIGHT LNE
// _,] \ , UP--DOWN
90°
.... iJ, [ _
ill
2 Hex Nuts 1/4-20
1 Hex Nut 1/2 in. - 13
1 Split Iockwasher 1/2 in,
2 Ext. tooth Iockwashers
2 10-32 x 1/4 Pan Hd. Screws
1 Belt Guard
3, Screw the sliding guard rod into the jointer as far as it
witl go with the short end of rod pointing straight up.
4. Tighten the 1/2" nut to hold the rod securely in this
position.
_I,POsitiOn the siiding:guard rod through the opening in
the belt guard as illustrated. 1/2" LOCKWASHER
2. Screw 1/2 °' nut alt the way onto long end of rod... \_ BELT
place 1/2" Iockwasher next to nut (as
illustrated),
_/i/4_:_ _ GUARD
1/2" X t _/ .//_ \SLIDING
HEX NUT [i _/ GUARD ROD
t
/
1/2" HEX NUT
GUARD ROD
5. Attach guard to stand with hex hd. screws and nuts,
Make sure belt does not scrape guard,
10