Installing Sliding Guard; Mounting Recommended Craftsman Motor And Belt Guards - Craftsman 113.20680 Owner's Manual

assembly
:= INSTALLING SLIDING GUARD
PARTS NEEDED
1; Sliding Guard
1: Sliding Guard Knob
1 Sliding Guard Rod
2 SlidingGuard Washers (one side of washer is concave)
1 Hex. Nut 1/2 in.- 13
1 Split Iockwasher 1/2 in.
2: EXt. tooth lockwashers
2 10-32x 1/4 Pan Hd. Screws
1. screw nut all the way onto long end of rod.., place
1/2 in. lockwasher next to nut.
2. Screw rod all the way into Jointer with short end up...
tighten nut.
1/2 IN. HEX NUT
SLIDING GUARD ROD
,: : i •:: i¸:•:I:
3. Attach sliding guard to fence with two machine screws
and Iockwashers.
4. Place one Sliding Guard Washer, concave side DOWN on
support rod.
5. Drop sliding guard onto rod.., place other washer, con-
cave side UP on rod.., screw on Sliding Guard Knob.
SLIDING GUARD KNOB
10-32xl/4 SCREWS
EXT. TOOTH
LOCKWASH ERS
WASHER
(CONCAVE SIDE UP)
MOUNTING RECOMMENDED CRAFTSMAN
MOTOR AND BELT GUARDS
See page 5 for recommended motors.
PARTS NEEDED
4 carriage bolts, 5/16 - 18 x 1 in., flat washers, lock washers
and nuts supplied with Craftsman Stand.
1 Jointer Planer Belt Guard
1 Motor Pulley Belt Guard
I Belt Guard Support
1 BeltGuard Support Bracket
3 Belt Guard Clips
1 : Motor Pulleys,2-1/2 in; dia.
11 V-Bett:..
2 Pan Head S_rews 10 - 32 x 1/2 in. ......... '
2 Hex. Hd. Screws 1/4 -20x 1/2 in.
2 Hex. Nuts 1/4- 20
TOOLS NEEDED
Medium Screwdriver
5/32 in. Setscrew Wrench (furnished with Jointer)
1/2 and 7/16 in. Wrenches
8