Craftsman 113.20680 Owner's Manual page 14

getting to know your iointer-planer
b,
I_oosen 90 ° stop screw with small screwdriver and
turn knurled sleeve which will cause fence to tilt.
Turn sleeve in either direction until fence is square
with infeed table;
NOTE: tf you cannot square fence by turning
knurled sleeve, loosen three screws "A'" and adjust
fence square to table.
45 o ST
KNURLED _:
SLEEVE_. _.
90 o. STOPS%
C.
d_
Tighten 90 ° stop Iockscrew and both fence lock
knobs.
If 90 ° reading on tilt scale does not line up with
top surface of the slide bracket, loosen screws
holding scale and move it... tighten screws.
SCALE
ADJUSTING
- _ SCREW
-., , oc sc.Ew
::.;:t_l_ II V_."'_ ADJUSTING
SCREW
BRAC KE T
e. Adjust 45 ° stop in the same manner.
NOTE: Tilt scale wilt not require adjustment if it
was adjusted for 90 c position;
..... • Ly:+-:
FENCE
HEAD
OF
SQUARE
INFEED
TABLE
14