On-Off Switch - Craftsman 113.20680 Owner's Manual

h. Loosen four lock screws 2 or 3 turns with t/2 in.
wrench.
v
VIEW LOOKING UP FOR PARTS IDENTIFICATION
Turning the LEVELING STUDS will RAISE or LOWER
the infeed table.
SCREWING in the studs will RAISE the table . , ,
UNSCREWING them will LOWER the table,
a. With a 3/4 in. wrench turn leveling studs until
infeed table is parallel with straightedge.
b. While holding studs with wrench, TIGHTEN all
four LOCKSCREWS... tighten each screw a little
bit at a time until all four screws are tight.
c. Recheck with straightedge to make sure infeed
table is parallel to outfeed table.
ill "
6. ON-OFF SWITCH:
It is untikely that it will be
turned "ON" accidentally, when touched or bumped,
because of the way it is shaped.
In an emergency, it can be turned "OFF" by striking
it with the palm of the hand.
The "yellow button" is a key. When inserted in the
switch lever, the power may be turned ON and OFF.
When it is removed, the power cannot be turned ON.
THtS FEATURE IS INTENDED TO PREVENT
UNAUTHORIZED AND POSSIBLE
HAZARDOUS USE BY CHILDREN AND
OTHERS.
a. Insert Key into switch. _
NOTE: Key is made of yellow plastic.
KEY
17