Advertisement
ADJUSTINGDEPTHOF CUT
SeeFigures 3,4, 5,and6,
Werecommend t hatcutsbemadeat
a depth not
exceeding 1,/8 in, and that several passes be made to
reach depths of cut greater than 1/8 in,
[] Unplug your router,
_
WARNING:
Failure to unplug your router could
result in accidental starting causing serious
injury,
[] Place router on a flat surface and loosen locking
arm, See Figure 3,
[] Turn the depth indicator ring until the zero lines up
with the indicator point on the base, See Figure 5,
LOCKING
LOOSEN
ARM
Fig, 3
[] Turn depth adjusting ring until cutter is inside
subbase, See Figure 4,
[] Turn depth adjusting ring until tip of cutter touches
flat surface,
CUTTERAT ZERO
DEPTHOFCUT
Fig, 5
[] Position router so that the cutter can extend below
the subbase for desired depth setting, See
Figure 6,
TO
RAISE
CUTTER
TO LOWER
CUTTER
INDICATOR
POINT
CUTTER
INSIDESUBBASE
SUBBASE
DEPTH
ADJUSTING
RING
DEPTH
INDICATOR
RING
Fig, 4
[]
CUTTEREXTENDED
BELOWSUBBASE
Fig, 6
Turn the depth adjusting ring to obtain the desired
depth of cut,
NOTE: You can read the distance the cutter moves
on the depth adjusting ring, Each major mark on
the depth adjusting ring indicates 1/32 inch change
in depth setting, Each minor mark indicates ,0004
in, The indicator point is located on the base,
Tighten locking arm securely,
10
Advertisement
