Setting Up Serial Communication; Connecting The Serial Cable - Epson ELP-3000 Owner's Manual

Setting Up Serial Communication

The RS-232C Serial Communication Kit allows your computer and projector
to communicate so you can access the projector menus from your computer
and use the remote control to control your computer. The kit consists of a
cable, a Macintosh adapter, and two software utilities: ELP Link and ELP
Remote Programmer.
Instructions for installing the cable and software are given in the next two
sections. For information on using ELP Link, see Chapters 2 and 3. For
information on the ELP Remote Programmer, see Chapter 4.
By default, the Serial setting in the Options menu is on to enable communication
when the Serial Communication Kit is installed. If, after installing the kit, you
cannot enable communication, make sure the Serial setting has not been turned
off. See Chapter 3 for more information about the menus.

Connecting the serial cable

To connect the serial RS-232C cable to your computer and projector:
1. Connect one end of the serial RS-232C cable to the projector's RS-232C
2. If you have a Macintosh, attach the RS-232C adapter to the modem port on
connector.
the Macintosh.
Setting Up Serial Communication
15