JVC KW-NX7000 Instructions Manual page 3

Cautions on the monitor:
• The monitor built in this unit has been produced
with high precision, but it may have some
ineffective dots. This is inevitable and is not
malfunction.
• Do not expose the monitor to direct sunlight.
• Do not operate the touch panel using a ball-point
pen or similar tool with the sharp tip.
Touch the buttons on the touch panel with your
finger directly (if you are wearing a glove, take it
off).
• When the temperature is very cold or very hot...
– Chemical changes occur inside, causing
malfunction.
– Pictures may not appear clearly or may move
slowly. Pictures may not be synchronized with
the sound or picture quality may decline in
such environments.
For safety...
• Do not raise the volume level too much, as this will
block outside sounds, making driving dangerous.
• Stop the car before performing any complicated
operations.
Temperature inside the car...
If you have parked the car for a long time in hot or cold
weather, wait until the temperature in the car becomes
normal before operating the unit.
Notes on the SD slot for System
updating:
The SD slot marked below is for System updating. To
update the System, ☞ page 18.
• Do not remove the cover in any case other than
updating the System.
SD slot for system updating
Every time you turn on the unit or attach the monitor
panel with the ignition switch turned on, the screen
below appears. Pay sufficient attention when operating
the unit and make sure of safe driving.
This unit functions properly only when the speed
signal lead is connected (refer to the Installation/
Connection Manual).
How to reset your unit
• Your preset adjustments will also
be erased.
How to forcibly eject a disc
Press and hold OPEN/TILT while holding
[Hold]
• If this does not work, reset the unit.
For security reasons, a numbered ID card is provided
with this unit, and the same ID number is imprinted on
the unit's chassis. Keep the card in a safe place, as it will
help the authorities to identify your unit if stolen.
3
/ATT.
[Hold]
INTRODUCTION