Starting The Projector With A Password - Epson PowerLite 1730W User Manual

8. To enable your screen logo, select
. Select and press
Enter On
When this feature is on, the logo appears whenever you turn on
the projector (if the
menu; see page 60). It also appears when you press the
button (if you selected the
Display in the Extended menu). None of the User's Logo features
in the Extended menu can be changed when the User's Logo
Protect function is enabled.

Starting the Projector with a Password

When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the button on the remote control and use the
Num
numeric keypad to enter the four digit password.
The password screen closes, the numeric keypad is automatically
deactivated, and projection begins.
If the password is not correct, you see a message prompting you to
re-enter the password. If you enter an incorrect password three times
in succession, you see the message
locked. Request code xxxxx
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector's power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
User's Logo Protect
.
Enter
is enabled in the Extended
Startup Screen
for the
Logo A/V Mute
The projector's operation will be
and the projector switches to standby
and press
A/V Mute
setting under
Fine-Tuning the Projector
59