Epson PowerLite 715C Quick Setup

Use these instructions to
set up your projector.
Using a laptop?
Follow these instructions to connect your laptop to the projector.
To connect other devices, such as a VCR or desktop PC, see your
User's Guide. You'll need just two cables: the power cord and
computer cable.
1
Make sure your projector and laptop are turned off.
2 Connect one end of the computer cable to the
Computer port on the projector.
Connect the other end to your laptop's video or
3
port. If you can't connect the cable to your PowerBook
may need to use an adapter. See your User's Guide
for instructions.
Plug in your projector
Connect the power cord to your projector and plug the other end into a grounded outlet.
The power light turns orange.
Extend the lens
Use the tab to rotate the lens ring, which extends the lens.
Then squeeze the tabs to remove the lens cap.
Turn on your equipment
1
Press the red Power button to turn on the projector. The
flashes green as the projector warms up, and the projection lamp comes on
in about 30 seconds.
2
If you're using a laptop, turn it on or restart it. (Windows only: If you see
this Add New Hardware screen, click Cancel.)
EPSON ® PowerLite

Quick Setup

Presenting without
a computer?
You can use EasyMP™ to run your presentation directly
from the projector. Follow the instructions below to start
the projector. Then see the back of this sheet for more help.
monitor
®
, you
power button
power light
Caution: Before unplugging the projector...
To shut the projector down safely, press the red Power button twice. Let the projector
cool while the power light flashes orange (about a minute). Once the light stops
flashing and stays on, it's safe to unplug the projector.
Never unplug the projector when the
® 505c/715c
tab
squeeze here
lens cap
power light is green or flashing orange.
Turn Over