Resetting The Lamp Timer - Epson PowerLite 765c Parts Manual

Epson PowerLite 755c/765c Projector
4. Loosen the two screws holding the lamp in place (you don't
need to remove them).
5. Hold the lamp as shown and pull it straight out.
Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
6. Gently insert the new lamp. (If it doesn't fit easily, make sure
it is facing the right way.)
Note:
The lamp(s) in this product contain mercury. Please consult
your state and local regulations regarding proper disposal or
recycling. Do not place in the trash.
7. Once the lamp is fully inserted, tighten its screws.
8. Insert the two cover tabs, then press down on the cover until
it snaps into place.
9. Reset the lamp timer as described in the next section.
24 Epson PowerLite 755c/765c Projector
-

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the
Replace the Lamp
Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the
Lamp Hours
hours that the lamp has been used.
1. Connect the power cable and turn on the projector.
2. Press the button on the remote control and select the
Menu
menu. Then press
Reset
3. Select
Lamp-Hours Reset
prompt:
4. Select and press
Yes
5. Press to return to the Reset menu or the
Esc
to exit the menu system.
8/05
message.
will not accurately reflect the number of
. You see this screen:
Enter
and press . You see this
Enter
.
Enter
Menu
button