Epson Weighing Indicator XK3190-A1+P User Manual page 8

step Operation
8
press [ 1 ] [ 5 ]
[ 0 ] [0 ]
press [ Enter ]
9 press [ Enter ]
10
press [2] [0]
[0][0] [0]
press [ Enter ]
11 press [ Enter ]
press [ Enter ]
press [ Enter ]
12
press [ 1 ]
press [ Enter ]
13
press [ 1 ]
press [ Enter ]
14
press [ 0 ]
press [ Enter ]
15
Note
: At step 6, 7, 8, 9, if press [ Weighing ] key, you can enter next step.
H. L. td indicating three calibrating coefficients .Recording them for spare use.
CAUTION!
When calibration is over, the calibration jumper must be pulled
X K 3 1 9 0 - A 1
Display
Loading weight ≥ 5% Max.。
[ A LoAd1]
[ d 1500 ] Example: 1500
After stable light is on, press [ Enter ]
key.
[ noLoAd ] Confirming zero position again.
Reloading weight on scale ≥50% Max.
[ ALoAd2 ]
It is better that this loading weight is
[ 20000 ] near the F.S. Example: 20000
After stable light is on, press [ Enter ]
key.
[H xxxxxx ] H. L. td indicating three calibrating
[L yyyyy ] coefficients . Recording them for spare
[td zzzz ] use.
[ Adr ** ] communication address (01-26)
[ Adr 01 ] Example: 1
[ bt * ] Serial communication baud rate ( 0-4).
It respectively represents baud rate: 600,
1200, 2400, 4800, 9600.
[ bt 1 ] Example: 1 (1200)
[ tF * ] Serial communication Mode:
[ tF 0 ] 0- Continuous transmitting mode,
1- Command response mode,
Example: 0
Weighing Calibration End.
mode
+P
Explanation
no receiving.