Advertisement
ASSEMBLY
OF HOPPER
BAG
•
Turn the upper hopper tube so that the middle
brace holes face down as shown in figure 8.
IMPORTANT:
The two holes in the middle of the
upper hopper tube must face down to allow assem-
bly of the support rods.
\
UPPER HOPPER TUBE
(brace holes on bottom)
•
Fit the ends of the (RH) and (LH) lower hopper
tubes together.
Align the holes in the tubes and
insert a plastic plug. See figure 10.
T
LOWER
HOPPER
LOWER
TUBE (RH)
HOPPER
PLASTIC PLUG
/
FIGURE 10
FIGURE 8
Insert the two side hopper tubes through the
stitched flaps on each side of the hopper bag. See
figure 9.
Assemble the ends of the upper hopper tube onto
the ends of the side hopper tubes. Fasten together
using plastic plugs. See figure 9.
_ PLASTIC PLUG
SIDE HOPPER TUBE
Place the assembled
lower hopper tubes into the
bottom of the hopper bag as. See figure 11.
Attach the ends of the lower hopper tubes to the
inside
of the side hopper tubes using two 3/8" x
1/2" clevis pins inserted from the inside, and two
3/32" hair cotter pins. See figure 11.
SIDE
\\
HOPPER
TUBE
3/32" HAIR
COTTER PIN
P
i
LOWER HOPPER TUBE
3/8" x 112"
CLEVIS PIN
HOPPER BAG
BOTTOM
FIGURE 9
FIGURE 11
7
Advertisement
