Hitachi XP P9500 User Manual page 104

>dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Remove LU
Intermittent Error Monitor
HDLM Manager Ver
Alive
HDLM Alert Driver Ver
Alive
HDLM Driver Ver
Alive
License Type Expiration
Permanent
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
Installing HDLM after an MSCS Installation
To install MSCS, and then HDLM on a host that does not currently
have HDLM on it:
1 Install MSCS on the host.
.
2 Restart the host.
.
3 Log on to Windows as a member of the Administrators group.
.
4 Save the license key file directly under the Windows installation-
.
destination drive. Also, instead of using the license key file, you can
directly specify the license key during the installation of HDLM.
installation-drive:\hdlm_license
The license key file will be deleted after the installation finishes.
5 Perform the installation.
.
¢
3-38
x.x.x-xx
x.x.x-xx
x.x.x-xx
-
If you are not performing an unattended installation, insert the DVD
into the drive.
In the displayed window, click the Install button next to for
Windows of Hitachi Dynamic Link Manager Software.
If no window is displayed, manually run the installer (setup.exe).
The program checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
: x.x.x-xx
:
: on(extended lio)
: on MSCS
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss 128
WakeupTime
yyyy/mm/dd hh:mm:ss
ElogMem Size
Migrating
3-64. If